Pay More Attention To Ultrafine Mill Maintenance

Ultrafine mill can be widely used in metallurgy, chemical, cement, ceramics, construction, electricity, medicine, defense industry and other departments, especially the Department of mineral processing in the metallurgical industry, as solid material refined into important equipment of powder grinding, it is also has a very important position. Its operation process is very important to its working state.

Precautions for maintenance of ultrafine mill

For the mill, as a user, we must pay attention to it, because it can make the ultrafine mill to create value for us, also makes it possible to safety production, therefore, in the process of operation, the user should pay more attention to it, so that it can be better used in the production. In order to make it better, the ultrafine grinding of the world is a summary of the following items.

1. The failure measures: in production, users first need to check the size of the material and the volume of the material. When the volume is too high, it will cause the blockage of imports. Also check whether the import seal has been worn out, after two periods of time, may be leaked, should be timely replacement of sealed packing.
2. Before the operation, we should do a good job of ultra-fine grinding equipment, so that it can make it better to adapt to production. Debugging is very important for production. The problems found in debugging can be avoided in practical work, so as to effectively improve the ultrafine mill.
3. The size of materials: in the work, for the difference of ultrafine grinding materials, it is possible to adjust the size of abrasive materials, so that users need to adjust according to actual needs, which is more consistent. Demand, users are more satisfied, and in the degree of two, it will save resources and avoid the waste of resources.
4. Import and export of abrasive material size effect: control into the ultrafine grinding of limestone particle size, so that in the scope of design and feed grain mill two size of 80% particles is less than 12mm.

When the user regulates the feed intake of the mill, the power consumption is reduced by two, and the mill should keep running under the rated condition. However, sometimes, due to various reasons, it is necessary to reduce the amount of feed according to the current reduction of the main motor of the grinding machine.